← Guide

Freeze a frame

You will stop the picture on one frame for a moment and then let the clip play on, for example to hold a funny face or to point something out. You can also turn a whole clip into one still frame.

Hold a frame for a moment inside a clip

  1. Click the clip on the timeline to select it.
  2. Move the playhead to the frame you want to hold. The Left and Right arrow keys move one frame at a time.

  3. Choose Clip > Retime Controls (Ctrl+R). A speed bar appears along the top of the clip, showing 100%.

  4. Click the small arrow in the speed bar and choose Freeze Frame. Kinoklip inserts a one-second freeze at the playhead, marked Freeze 0% (1). The clip gets one second longer and the clips after it move to the right; after the freeze the clip plays on from the same frame.

    A clip with a freeze in the middle, shown by the retime controls

  5. To hold the frame longer or shorter, drag the small handle at the bottom of the line at the end of the freeze (2) to the right or to the left.

  6. Press Ctrl+R again to hide the retime controls.

The frozen part is silent. To remove the freeze, click the arrow in the freeze part and choose Reset Clip (this also removes any other speed changes of the clip), or press Ctrl+Z right after adding it.

Turn a whole clip into a still

  1. Select the clip.
  2. Move the playhead to the frame you want to see.
  3. Choose Clip > Freeze Frame (Shift+R).

The clip keeps its length but shows only that one frame. If the playhead is not over the clip, it shows its first frame. Undo with Ctrl+Z.

A common way to use this: cut a clip at the playhead (Ctrl+\), cut it again a few seconds later, select the middle part and press Shift+R. The middle part now shows the frame where it starts.

Tips

If something goes wrong

  • Freeze Frame is greyed out in the speed menu. The playhead must be over the clip. Click in the ruler above the clip first.

  • Everything after the clip moved. That is normal for a freeze inside a clip: the video gets longer by the length of the freeze. Use Shift+R on a cut-out part instead if the length must not change.