← Guide

Track a moving thing and warp the picture

You will make a graphic or a clip follow something that moves in the footage, pin a graphic to a bending surface, and bend a picture by hand. The effects are in the Effects library, folders Transform (Match Move, Surface Tracker) and Warp (Warper), and work like the effects with the same names in DaVinci Resolve.

Make a graphic follow a moving thing (Match Move)

  1. Put the footage on a video track and the graphic (a title, a picture, a solid) on the track above it. Place the graphic where it should sit at one frame of your choice.

  2. Move the playhead to that frame and add Match Move to the graphic (Effects tab of the Inspector, Add Effect, Transform).

  3. Set Track to Footage Below. Put the Region on the thing to follow: Region X and Region Y are its centre in percent of the picture (50 and 50 is the middle), Region Size its width. Choose a corner or an edge with some detail, not a flat colour.

  4. Click Track Forward to follow it from the playhead to the end of the clip, and Track Backward to follow it to the start. A progress bar shows; you can keep editing, and Cancel stops with the clip unchanged.

  5. Play the clip. The graphic stays where you put it at the playhead frame and moves with the thing from there.

Other settings:

  • Tracking: Position follows one point. Position, Scale and Rotation follows a square region and also turns and enlarges the graphic when the thing does.

  • Direction: Follow the Track moves the clip with the thing. Hold the Track in Place does the opposite, so the thing stays still and the picture moves around it (set Track to This Clip to steady a clip on a feature).

  • Strength is how much of the movement is used. Offset X and Offset Y shift the clip away from the thing, and can be animated.

If you change Track, Tracking or the region after tracking, the old track is not used and the effect says Track again. The other settings change the picture at once. Clear Track throws the track away. The track is saved in the project with the clip and follows it when you trim, split or change its speed, but if you move the graphic against the footage, track again.

Pin a graphic to a bending surface, or bend the picture (Surface Tracker)

Use Surface Tracker when the thing moves and also bends or turns, like a flag, a sheet of paper or a screen filmed at an angle.

  1. Add Surface Tracker (Transform folder) to the clip, set Track (Footage Below for a graphic above the footage), move the playhead to the frame where the graphic should sit.

  2. Cover the surface with the region (Region X, Y, Width, Height). Grid Density is how many points follow the surface on each side: more points follow a stronger bend.

  3. Click Track Forward and Track Backward, as with Match Move.

  4. Apply chooses the result: Pin to the Surface moves the graphic with the surface, and Warp with the Surface bends the clip's own picture the way the surface bends. Smoothing calms jumpy points.

Like Match Move, the track is stored with the clip and a change of region, grid or source needs a new track.

Bend a picture by hand (Warper)

Add Warper (Warp folder). It lays a grid of points over the picture: Columns and Rows set how many (3 by 3 to start, up to 4 by 4). Each point has Point row, column X and Y, how many pixels it moves right and down (row 1 is the top row). The picture bends smoothly with the points, and the edge of the grid holds the picture there. Every point can be animated with keyframes, so a mouth, a flag or a logo can be made to ripple and sway.