Record a voice-over
Speak your narration while the video plays, and Kinoklip puts the recording on an audio track, lined up with the picture. You need a microphone (or any audio input) connected to the computer. Use headphones for the timeline's sound: the microphone is never played back through the speakers, but the speakers' sound would reach the microphone.
Record
-
Put the playhead where the narration starts. The timeline plays from there, so it must be before the end of the timeline.
-
Click the R button in the header of the audio track you want to record onto (on the Edit page or the Audio page; the mixer strip on the Audio page has one too). The button turns red and a thin level bar appears along the foot of the header: speak and watch it move. Keep the bar out of the red part; a red mark at its end shows that the sound was too loud and distorted for a moment.
-
To record from another microphone, right-click the R button and choose an input. The first entry, Default, follows the setting in Preferences > System > Audio I/O.
-
Click the red Record button in the viewer's transport bar, or press Ctrl+Alt+R (Playback > Record Voice-Over). Numbers count down over the picture (3, 2, 1). When they end, the timeline plays and REC shows in the corner of the picture. Speak.
-
Press Space (or Stop) to end the take.
Only one track can be armed at a time: arming another track moves the red button. Click the red R again to disarm. Arming is not saved with the project.
The recording is added to the track at the place where you pressed Record, over whatever was there, as one step: Ctrl+Z takes the whole take away again and restores the clips it covered.
Where the takes go
Every take is a WAV file called after the track and a number, for example A1 take 1.wav:
- In a normal project it is saved in a folder named Voice Over next to the project file.
- In a single-file project it is copied into the project file, like any imported file.
Each take is also added to the Media Pool, in a bin called Voice Over. Earlier takes stay there, so you can try again and still use the first one: drag it from the pool onto the timeline.
Settings
Open Preferences > System > Audio I/O:
- Input device: the microphone used by tracks that you have not given their own.
- Voice-over count-in: 0 to 10 seconds. 0 starts at once.
- Voice-over extra latency: see below.
- Voice-over WAV format: 24-bit (default) or 16-bit.
If the voice comes in late
A microphone and the computer need a moment to deliver the sound, so a recording is always a little behind what you said. Kinoklip subtracts the delay that the microphone reports, but many do not report it. If your voice is still late against the picture, raise Voice-over extra latency by 20 to 50 ms, record a short test and look again. The file keeps the whole recording, so you can also move the sound with Slip.
If something goes wrong
-
The R button is grey, or a message says there is no microphone. Connect a microphone and try again. The tooltip of the R button names the problem. If the message says the system does not let Kinoklip use the microphone, allow it in the system's privacy settings.
-
Record says there is nothing to play. The playhead is at the end of the timeline. Move it earlier: the recording stops where playback stops.
-
Nothing was recorded. The microphone delivered no sound. Check the chosen input and the system's input volume.
-
The track is locked. Unlock it first.
Found a mistake? Edit this article on GitHub.