← Guide

Steady a shaky clip

You will take a clip filmed by hand, with the camera trembling or swaying, and make the picture calmer. Kinoklip measures how the camera moved during the clip, then moves the picture the opposite way, frame by frame. It works like the Stabilization section of DaVinci Resolve's Inspector.

Only clips of video files can be stabilized. A still picture, a title or a frozen frame has no camera movement to measure.

Stabilize a clip

  1. Click the clip on the timeline to select it, and open the Video tab of the Inspector.
  2. Find the Stabilization section, between Speed Change and Retime and Scaling.
  3. Choose the Mode, which says what kind of camera movement is corrected:

    • Perspective: everything, including the picture tilting in depth. The most powerful choice, and the one to start with.

    • Similarity: pan, tilt, rotation and zoom, but no tilting in depth. Steadier when Perspective makes the picture wobble.

    • Translation: pan and tilt only. For a camera that shakes up, down and sideways but does not turn.

  4. Click Stabilize. A progress bar shows while Kinoklip looks at the clip. You can keep editing; click Cancel to stop, and the clip stays as it was.

  5. When the message says Stabilized, play the clip. Click the switch in the section header to compare the clip with and without the correction.

The result is saved in the project with the clip, and Ctrl+Z undoes the whole step.

Adjust the result

These controls work at once, without measuring again:

  • Smooth (0 to 1): how calm the new camera path is. Low values follow the camera closely and only take out small shakes. High values give a very steady picture, as if the camera were on a slow, smooth rail; a slow pan stays, a jerk goes. 0 corrects nothing.

  • Camera Lock: removes all camera movement, like a camera on a tripod. Smooth and Cropping Ratio do nothing while it is on.

  • Zoom: the correction moves the picture, which leaves empty edges. With Zoom on, Kinoklip enlarges the picture just enough to hide them in every frame of the clip. With it off, you see the moving edges and the picture keeps its size.

  • Cropping Ratio (0.25 to 1): how far Zoom may enlarge the picture. At 1 it may enlarge up to twice; at 0.25 only a quarter more, and strong corrections then show some edge.

  • Strength (-1 to 1): how much of the correction is applied. 1 is all of it, 0.5 half, 0 switches the correction off, and a negative value shakes the picture the opposite way.

Only changing the Mode needs a new measurement: press Stabilize again, and until you do the old measurement is not used (the section says so).

Good to know

  • The measurement follows the parts of the picture that move together, so a person walking through the scene does not pull the picture along. Pictures with little detail (a plain sky, a white wall) are hard to follow; Kinoklip leaves such stretches as they are and tells you how many it could not match.

  • You can trim, split, slow down or reverse the clip after stabilizing it: the correction belongs to the frames of the video file, so each frame keeps its own. Frames you stretch the clip to that were not part of the measurement are shown uncorrected; press Stabilize again.

  • The correction is applied before the clip's own Transform and Cropping, so you can still move, zoom and crop the clip as you like.

  • From the command line or an AI assistant, use clip stabilize (see Control Kinoklip from the command line).